Category: 

Which is More Efficient: Solar or Geothermal Power?

Solar panels pointed at the sun to absorb solar energy.
Article Details
  • Written By: Ken Black
  • Edited By: Andrew Jones
  • Last Modified Date: 03 October 2014
  • Copyright Protected:
    2003-2014
    Conjecture Corporation
  • Print this Article
Free Widgets for your Site/Blog
Waking up in the middle of the night is normal for humans.  more...

October 31 ,  1984 :  Indira Gandhi, Prime Minister of India, was assassinated.  more...

A discussion on the efficiency of solar or geothermal power needs to look at many different aspects, making this question not as black and white as it may appear at first glance. First, efficiency needs to be defined. Second, local conditions need to be taken into account. Third, the use of the energy and the setting need to be taken into account. This last category will also include whether the efficiency is in terms of using it for a home, or a commercial environment.

Overall, when considering types of power, solar or geothermal power each offer some very good alternatives to traditional power sources. Solar panels, even the best on the market, may only convert a small percentage of their energy to electricity, often 20% or less. Geothermal power may not offer any better of a solution. In fact, geothermal power is not used at all for electricity production for individual homes. To use geothermal for electrical generation, it is necessary to use very hot temperatures near the Earth's surface. The conditions for this type of generation are available in only a few places on the planet, such as Iceland, and once a source it is tapped, it general is used to provide for an entire community. The average efficiency of geothermal power plants is approximately 16%, making them comparable to solar forms of energy.

Ad

Efficiency can be defined as a ratio. On one side you have the energy input, and on the other side you have the energy output. To make the energy useful, be it solar or geothermal, a conversion must take place. For example, a furnace must take the energy it receives, and convert it into heat. During this conversion, a process known as entropy takes place, which simply means the energy potential is less than what existed in the original state. This is also known as the second law of thermodynamics. The entropy is deemed expendable, simply because the process creates a more practical use for the energy.

In most cases, while energy efficiency will result in lower energy bills for the individual, that may not always be the case with solar or geothermal energy. The most significant costs, in both cases, are the installation costs. The equipment and installation for both can be somewhat expensive. Also, the inputs may not be the same in all areas. For example, it may be possible to have a very efficient solar system, capable of converting most of the sun's energy to useful electricity, or other forms of energy, but if there is no direct sunlight, then the most efficient system in the world will do no good.

When considering solar or geothermal this is why location is so important. Of course, geothermal energy is available anywhere, to some extent. The process of drilling to get the geothermal energy may not be easy, depending on the ground conditions. This could lead to extra expense. Thus, even though the technique may be very energy efficient, it may not be very cost efficient.

Ad

More from Wisegeek

You might also Like

Discuss this Article

highlighter
Post 3

@Anon138425- A multi-meter should work fine for your experiment. You will be able to test the milli-amps of the photovoltaic cell for each color sheet.

submariner
Post 2

@Anon138425- Removing any wavelength of light from the spectrum will decrease the power output of a solar panel. Some colors will also block more energy form reaching the solar panel than others. If you have access to a solar energy home, you can actually try this experiment to see the effects for yourself.

Smaller wavelengths of light have higher frequencies and higher energy. Colors on the blue end of the spectrum have shorter wavelengths than colors on the red side of the spectrum. Placing a violet or blue screen over the solar cell will cause the cell to produce less electricity than if you were to place a red or yellow screen over the cell. In theory, the most efficient solar cells will be able to absorb the widest spectrum of light if all other factors are the same.

anon138425
Post 1

Would the color of sun rays affect the absorptions of the solar cell? If, for example, i placed a yellow colored sheet on one panel and a red colored sheet on another, would the other charge or absorb more or faster than the other? Would a battery tester be all right to be able to gauge the solar panels' charged stage?

Post your comments

Post Anonymously

Login

username
password
forgot password?

Register

username
password
confirm
email