Category: 

What is the Morse Taper?

Article Details
  • Written By: Jennifer Voight
  • Edited By: Jacob Harkins
  • Last Modified Date: 03 November 2016
  • Copyright Protected:
    2003-2016
    Conjecture Corporation
  • Print this Article
Free Widgets for your Site/Blog
President Richard Nixon had an entire speech prepared in case the Apollo 11 astronauts became stranded on the Moon.  more...

December 8 ,  1965 :  Pope Paul VI promulgated Vatican II into ecumenical law.  more...

A Morse taper is a standard system for securely attaching drill bit tools to the drill press machine spindle. During rotation, the part is held in place by friction of tapered shanks against the hollow spindle that holds the tool. Attachments with a tapered shank can be fitted and removed quickly and easily so the user can have a greater variety of bit sizes available.

There are many families of drill bits in existence that are distinguished from other tapered drill bits in the degree that they taper from wide to small end. Morse tapers will narrow approximately 5/8 inch (1.5 centimeters) per foot (30.4 centimeters). Each of the eight sizes is identified by a number between 0 and 7, with the most commonly used being size 2, or 2MT. Small numbers correspond to smaller diameter parts and large numbers to larger diameters.

Drill press accessories have a tang, or prong, end that allows the bit to fit snugly into the slot in the spindle of the machine. The taper positions and holds the bit in place with friction. During light drilling, friction is adequate to hold the tool in place. Heavier drilling with stronger forces may cause the bit to spin in the hole instead of drilling.

Ad

To secure the bit more tightly, the tang end of the Morse taper shank fits into a slot in the socket. This will keep the drill bit spinning even when the drill encounters heavy resistance. Once the drill bit is fitted into the socket of the drill press by hand, it is turned until the tang clicks into place. The entire assembly is then pressed against a block of wood or metal to secure it tightly into the socket so it does not spin during use. The bit may also be tapped with a brass or lead hammer until it fits tightly.

Despite the variety of sizes, sometimes a longer or wider diameter shank is needed to fit the accessory into the machine. Socket extensions will increase the length of the bit. Sleeve adaptors add width to the drill bit so it will fit into a larger socket.

The Morse taper was invented by Charles A. Morse, a machinist in the 1860s. His taper was adopted as ISO 296 standard by the International Organization for Standardization and as DIN228-1 by the German Institute for Standardization. A Morse taper will fit antique drill presses as well as a modern drill press.

Ad

You might also Like

Recommended

Discuss this Article

hamje32
Post 2

@MrMoody - A regular drill chuck should do the job for your hand held drill. I do believe that I’ve seen some of these with morse tapers sold in the home improvement stores, but I’ve never purchased those myself. I just bought the drill chucks in various sizes and they worked fine.

MrMoody
Post 1

Although it doesn’t say, I take it that the morse taper adapter is more useful for industrial drill presses than household, hand held drills. If that is the case, that’s too bad, because I can think of several situations where I could have benefited from something like this.

I was doing a wood working project with thick beams of wood, and the drill met with heavy resistance. I mean, sparks were flying. A couple of times the drill bit came loose and I had to reinsert it back into the drill. A morse taper would have been useful in that situation, in my opinion.

Post your comments

Post Anonymously

Login

username
password
forgot password?

Register

username
password
confirm
email