Category: 

What is Flat Iron Steak?

Article Details
  • Written By: Mary McMahon
  • Edited By: Bronwyn Harris
  • Last Modified Date: 23 July 2014
  • Copyright Protected:
    2003-2014
    Conjecture Corporation
  • Print this Article
Free Widgets for your Site/Blog
More bank robberies occur on Friday than any other day of the week.   more...

July 30 ,  1945 :  The USS Indianapolis was torpedoed after dropping off key components of the Hiroshima atomic bomb.  more...

The flat iron steak is a cut of beef which was discovered by researchers at the University of Nebraska. The researchers were trying to figure out how to use traditionally less desirable cuts of beef, and in the process, they found this extremely tender cut of meat. The cut is also called a top blade steak, in a reference to the region of the cow that it comes from.

The steak is cut from the area just behind the shoulder of a cow. Traditionally, the large cut of meat from this region has been called a blade roast. The meat was generally viewed as tough, suitable for stewing or roasting but not for grilling and other delicate cooking processes. However, a closer examination of the meat led to the discovery that this long held opinion is actually false.

The very top of this cut is really quite tender, but it must first be separated from the rest of the roast. Each shoulder actually yields two flat iron steaks, which are connected by a band of dense connective tissue. This tissue led people to believe that the steaks around it would be stringy and tough, as most cuts of meat surrounded by connective tissue are. This turned out not to be the case; in fact, flat iron steak is one of the most tender cuts of meat.

Ad

The origins of the name are a topic of debate. The most obvious explanation is that the steak does resemble an old fashioned triangular flat iron. Some people have also suggested that the steak was named for its supposed hardness, which would have rivaled a solid metal flat iron.

Like many steaks, flat iron steak certainly benefits from being marinated. It does extremely well on the grill, and can also be prepared like other steaks would be. Just as with high quality steak, overcooking tends to turn the meat stringy and dry, rather than tender and moist. It can also be cut into strips for fajitas and stir fries.

Ad

Discuss this Article

anon310565
Post 8

My wife and I have been using flatiron steak for a while now. We buy them at M&S. I used their instructions: start on a very hot grill and lightly oil the meat, add a little salt and pepper, put the meat on the very high heat and listen to the sizzle. Leave on this heat for about a minute and a half, and turn over. Leave on high for another minute, turn the gas off for two minutes, then turn back on medium heat for a further two minutes. Coat the top surface in butter, turn over and cook for a further two minutes, remove and allow to rest on a warm plate covered in foil for three minutes and serve. This will be medium rare and will absolutely melt in the mouth. Lovely.

anon175905
Post 7

The best flat iron steak you will ever eat will have no marinade. For this steak, it's all about the cooking process.

It's best on the grill, but I have cooked it indoors in the winter. Salt and pepper should be all you need. Preheat the grill to at least to 500 to 600 degrees. You want it really hot. Coat the meat with oil, put on the grill and close the lid. After two minutes, rotate the steak a quarter turn. After three minutes, flip it and repeat the process and times. Remove and tent it with foil for four or five minutes. It will be medium and absolutely melt in your mouth.

If indoors, sear it in a iron skillet on both sides on high. Then broil it using the same grilling times. the kitchen gets a little smoky, but it's still good for a winter steak or in the absence of a hot grill. Don't overcook. This is not not a cut meant to be well done.

anon155359
Post 6

I marinate flat iron steak in Dale's sauce at room temp for few hours.

anon147836
Post 5

Can someone tell me if flat iron steaks can be considered as part of the Chuck?

anon125868
Post 4

Flatiron steak is the best there is. No need to marinate. Just grill it and definitely don't overcook it.

yournamehere
Post 3

Would you say that a sirloin steak or a flat iron steak would be better for a first-time steak griller?

I know that a sirloin is more classic, but a flat iron looks like it might be good too -- what do you think?

StreamFinder
Post 2

My local butcher recently started stocking pork flat iron steaks. They make a fantastic grilling steak -- I've found that you get a lot of the benefits of a good beef flank steak, but with the lighter taste of pork.

You should be aware though that this is a hefty cut of meat, and does do better if you marinate it, but if used improperly, it works well for grilling, baking, sauteeing and broiling.

rallenwriter
Post 1

I recently discovered flat iron steak by watching food network, and I have to say it sounds very tasty.

They used a steak marinade made of honey, Worcestershire sauce, balsamic vinegar, olive oil, and lemon juice, plus what sounded like 30 different spices. It sounded fantastic, but was a little much for a first time marinader like me to undertake.

Does anybody have a really good beef flat iron steak recipe that doesn't call for an insane marinade, or at least one that has a marinade that is simple to make?

I'd like to move away from my rib eye and steak sauce days, but I need a little help getting there.

Any advice?

Post your comments

Post Anonymously

Login

username
password
forgot password?

Register

username
password
confirm
email