Learn something new every day
More Info... by email
Dewatering refers to the removal of unwanted water. It may be the removal of ground water, process water, water entrained or carried along by oil or gas, or water used to transport solids. The equipment choice is based on factors such as a permanent versus a temporary operation, a batch versus a continuous process, and the percentage of water that must be removed.
Water used to carry a solid is called slurry. Coal slurry pipelines, for example, pipe ground-up coal particles carried in a water stream. Gold panning was another operation that took advantage of the transport possibilities of water. The materials transported by the water are referred to as the solids. Once the solids are concentrated, they are referred to as sludge or cake.
In many slurry operations, the water may have to be pressed out or the solids filtered out. Often, agents that promote clumping of the solids, called flocculants, are added to the sludge to enhance dewatering. Dewatering conveyor belts, which may include heat and vibration as well, have perforations in the belt that drain water as the sludge is moved. Belt presses squeeze out the water by passing the slurry between a lower dewatering conveyor belt and an upper weighted belt. Screw conveyors, mixing tanks, or similar equipment mix air at a controlled temperature and humidity with the sludge, and water is carried away with the air flow.
In the drilling and mining industries, dewatering refers to the removal of ground water from mines and drill holes. Roadway construction and any excavation activities also may require temporarily altering the water table or rerouting ground water flows. The water may be pumped out, or drainage ditches and collection ponds may be built. Cofferdams, which are temporary dams made with sheets of metal, are used to temporarily hold back the water. Crude oil and natural gas are dewatered to remove entrained water by passing the flow through physical separators.
Construction sites, industrial plants, and similar environments often use water to control dust, to clean equipment, or as a byproduct of a process. If this water accumulates, it must be removed from the site without contaminating ground water. Metals may be reclaimed from mine waste ponds by floating the metal away from the water using flotation agents. The agents can be chosen so that economically viable concentrates of individual metals may be achieved.
Weir tanks are used to settle solids. They consist of long tanks with separators that the water has to either flow under or over. Simple but limited in application, a gravity bag filter is a long tube in which the water is pumped in and allowed to seep out. Mesh filters on the entrance to any downstream dewatering process removes solids of a given size distribution. Sand, carbon, or other materials filters may produce water of drinking quality, but these are usually considered water treatment steps.
Wellpoints consist of a series of pipes placed below the level of excavation. The pressure created by the water table helps drain water. Pumps pull the initial vacuum to start the siphoning of water and supplement the water flow if the pressure is insufficient.
One of our editors will review your suggestion and make changes if warranted. Note that depending on the number of suggestions we receive, this can take anywhere from a few hours to a few days. Thank you for helping to improve wiseGEEK!