Category: 

What Is a Globe Valve?

Article Details
  • Written By: Lea Miller
  • Edited By: R. Halprin
  • Last Modified Date: 15 July 2014
  • Copyright Protected:
    2003-2014
    Conjecture Corporation
  • Print this Article
Free Widgets for your Site/Blog
The average amount stolen in a U.S. bank robbery is about $7,000.  more...

July 26 ,  2006 :  Andrea Yates was found not guilty of killing her five children by reason of insanity.  more...

A globe valve is a mechanism used to control or stop the flow of liquid or gas through a pipe. The seat of a globe valve is in the middle of and parallel to the pipe, and the opening in the seat is closed off with a disk or plug. Globe valves can be structured to handle flow in either direction.

A globe valve is formed by a baffle that splits the interior of the pipe, usually parallel to the length of the pipe. The baffle contains an opening that is sealed by means of a disc or flat plug being pushed down into the opening, or seat, perpendicular to the pipe, to stop the flow through the pipe. A structure called a bonnet outside the pipe holds a stem that is connected to the disc. A handwheel at the top of the bonnet is used to manually screw down the stem with the disc at its end until the disc seals against the seat opening. In large industrial applications, a globe valve may be sealed using an electrical, pneumatic, or hydraulic actuator instead of a manual handwheel.

Ad

These devices are sometimes referred to as throttle valves because they can reduce the flow through the pipe. If the sealing disc is moved part of the way toward the seat opening, the space through which the product can flow is limited and therefore the flow is limited. This type of valve offers good control to regulate the flow of liquid. Water pipes are often fitted with a globe valve so the operator can control the flow of water through the pipe by opening the valve only partially or all the way.

This valve can also be set up to close with or against the flow of product. If the product flows in the same direction that the disc is closing, the flow will aid the closure of the seal but make opening harder. Conversely, if the flow goes against the direction of the disc closure, it will be easier to open the valve and more difficult to close it.

The baffle inside a globe valve causes the product to divert its direction to move through the baffle. This angled movement means that the product cannot flow as freely and causes a pressure drop after the valve. Globe valves are generally unsuitable for slurries or thicker substances that can be impeded by the baffle.

Ad

Discuss this Article

hamje32
Post 2

@nony - So I guess that the globe valve is similar in some sense to a check valve. With a check valve you restrict water flow so that it only flows in one direction, and never returns back to its original channel.

I see the globe valve being somewhat similar, except it restricts water by using the baffle, to direct it in one direction or another as you want.

nony
Post 1

We have a globe valve attached to our backyard water faucet. I don’t know that it’s shaped like a globe but the function is the same. It has a stem and I can attach faucets to either side of the stem.

This is useful when I want two hoses connected at all times, one that is used to irrigate my garden and one that I use to water the back lawn. I can switch and direct the water flow between either of them as needed.

It’s a practical device; without it, I would be stuck with one hose for both tasks.

Post your comments

Post Anonymously

Login

username
password
forgot password?

Register

username
password
confirm
email