Category: 

What Is a Drill Rod?

Article Details
  • Written By: Lori Kilchermann
  • Edited By: Jacob Harkins
  • Last Modified Date: 11 December 2014
  • Copyright Protected:
    2003-2014
    Conjecture Corporation
  • Print this Article
Free Widgets for your Site/Blog
A red blood cell can pass through a person's entire body in 20 seconds.  more...

December 19 ,  1998 :  President Bill Clinton was formally impeached by the House of Representatives.  more...

A drill rod is made of a very high carbon steel, and it is used to manufacture drill bits, taps, dowel pins and roller bearings. A drill rod is also used in the manufacturing of hammers, files and punches. The level of carbon used in making steel determines its hardness. The drill rod is sold in lengths typically 36 inches (91 cm) long and in varying diameters from 1/16 inch (1.5 mm) to 2 inches (5 cm) around or larger. The rod can also be manufactured in a square design.

There are two basic types of drill rod: water and oil hardened. A water hardened drill rod is used in the manufacture of hammers and files due to the drill rod not being heavily alloyed. This allows the material to be more easily machined than the oil hardened drill rod, although a water hardened rod is not well suited to welding. On the other hand, the oil hardened drill rod is easily welded and machined, it is well suited for general tool making due to its long lasting toughness.

Ad

In the process of water hardening, the rod is heated until cherry red and then plunged into a vat of water and allowed to cool. This creates a hard, durable product that is still easily machined. When the rod is heated to a cherry red color and then plunged into a warm oil, the surface becomes extremely hard and will damage most cutting tools. Therefore, these rods must have all of their machining finished prior to the oil hardening.

Depending on the intended use, some rods must be tempered prior to machining. To temper steel, it must be heated back up slowly after it has been water or oil hardened. By heating the steel to around 800 degrees Fahrenheit (426 degrees Celsius), the hardness is relieved a bit and the steel is more workable. Once brought up to temperature, the steel is allowed to air cool. Once cooled, the part can then be polished.

The difference in water and oil hardening is that water is a much better heat conductor and cools the rod faster. The parts must not be swirled in the water as this promotes much faster cooling on the side of the tool that is being pushed through the coolant. This can cause warping as the sides cool at different rates. This is critical when creating precision work pieces. When knife building, the steel should only be quenched in a straight up-and-down motion.

Ad

More from Wisegeek

You might also Like

Discuss this Article

BigManCar
Post 2

@MaPa - It's interesting that you say that. I work in a machine shop and we pretty much exclusively use the oil hardened drill rod material, but then we do a lot of welding so we need it most of the time. You're right, though, it's really picky when you shape it compared to the water hardened.

MaPa
Post 1

I have worked with drill rod stock for a lot of years, and I always preferred to work with the water hardened stock rather than the oil hardened. I have used both, but it always seemed to me that it was easier to work with the water hardened for the kind of things we did. The oil hardened stock was really picky when we were shaping it on the lathe, and it was easy to ruin a piece of stock.

Some applications just don't lend themselves to using water-hardened stock, but for those that do, I prefer it.

Post your comments

Post Anonymously

Login

username
password
forgot password?

Register

username
password
confirm
email