Learn something new every day More Info... by email
There are many ways of making a robot, and a few tips can help do-it-yourself (DIY) robotics enthusiast make an effective and affordable robot. A DIY robotics project can get expensive, especially with large robots, so it may be best to start with a smaller robot that costs less and is easier to construct. Using a separate power supply can be a good idea, because this keeps to a minimum the fluctuating power and noise that can destroy sensors. When running a robot, many of the pieces tend to get hot, but adding copper fills to a robot can help sweep heat away from the important parts. Builders also should place wires as far away from input lines as possible to reduce noise.
Many DIYers are ambitious and want to create large robots, but they may not have the money for these projects. Larger robots also are typically hard to move. Scaling back a DIY robotics project and making a smaller robot may be cheaper and easier. Smaller robots also typically are lighter, so they usually can move faster.
When robots are working, their power supply can produce inconsistent voltages that can make robots turn on and off while they are moving. This also can produce excess noise, which can destroy the motor, inputs and other parts. Using a separate power supply with DIY robotics reduces the chance of inconsistent voltages, which can help robots move smoother and typically will increase their functional life.
Robots, like many hardware systems, tend to get hot while moving. This heat can cause parts to wear down or melt, which decreases a robot's life and efficiency. To fix this DIY robotics problem, copper fills can be used. Copper is commonly used in computers for this same purpose, because it is capable of taking the heat and directing it away from important components. The copper fills should be placed below chips; they do not need to be electronically connected, the copper just has to be there.
There typically are many wires involved in DIY robotics, and the wires tend to go everywhere. To help keep robots moving, it may be a good idea for builders to move these wires away from input lines. When wires and input lines touch, this creates electrical noise, which disrupts signals and can even destroy parts. Keeping these wires as far away as possible from input lines can keep robots from malfunctioning or dying early.
One of our editors will review your suggestion and make changes if warranted. Note that depending on the number of suggestions we receive, this can take anywhere from a few hours to a few days. Thank you for helping to improve wiseGEEK!