Category: 

How Do I Install Wainscoting?

Article Details
  • Written By: Lou Paun
  • Edited By: Bronwyn Harris
  • Last Modified Date: 04 October 2014
  • Copyright Protected:
    2003-2014
    Conjecture Corporation
  • Print this Article
Free Widgets for your Site/Blog
Coloring your hair in the ‘30s often came with swollen eyelids, blisters and headaches.  more...

October 21 ,  1879 :  Thomas Edison lit up a light bulb for the first time.  more...

At one time, when wainscoting was built on-site, it took a master carpenter to install wainscoting. Today, prefabricated wainscoting panels are available. It is now possible for a do-it-yourselfer to install wainscoting.

Wainscoting panels, like other wood products, expand and contract slightly as the moisture content in the room changes. A small gap of about 1/16 inch (0.16 cm) between panels will accommodate this movement. It is advisable to leave the panels in the room where they will be mounted for at least 24 hours before installing wainscoting.

The first step to install wainscoting is to mark a level line for the top of the panels using a straight edge and a level. An older house may have slightly uneven floors or walls caused by the house settling over time. Creating a level top line when starting to install wainscoting eliminates any problems from the settling.

Always start to install wainscoting in a corner and work around the room. Start installation with a full panel. Make sure the top of the panel is even with the line, and use adhesive and paneling nails to hold it in place. Leave a small gap and mount the second panel in the same way.

Ad

It will probably be necessary to cut panels at the corner of the room to install wainscoting. Cut the panel 1/8 inch (0.32 cm) smaller than the length of wall to be covered. Install the new panel 1/16 inch (0.16 cm) from the previous panel, leaving a 1/16 inch (0.16 cm) gap in the corner.

Wainscoting panels can easily be cut with a jigsaw. Measure carefully when cutting openings for outlets and switches. Don’t replace switch plates and outlet plates until installation is complete.

The last task to install wainscoting is to mount the wainscoting cap at the top of the panels and the baseboard along the floor. The wainscoting cap visually divides the wainscot from the upper wall. The baseboard covers any gaps or uneven places near the floor.

Ad

More from Wisegeek

You might also Like

Discuss this Article

Post your comments

Post Anonymously

Login

username
password
forgot password?

Register

username
password
confirm
email